Char-Broil GRILL2GO X200 Product Manual page 6

LP Gas Container Installation/Removal
LP Gas Container Installation:
1. Remove cap from end of Propane container (sold separately).
2. Cap should be kept on container when not in use to prevent dirt
and debris from entering Regulator/Valve.
3. Check end of container attachment for dirt and debris. Clean
out if necessary.
4. Insert threaded end of LP Gas Container into Regulator/Valve
and hand-tighten turning container clockwise as shown below.
DO NOT USE TOOLS! Over tightening can damage threads
on Regulator/Valve.
Regulator/Valve Installation/Removal
1. With knob pointing to back of barbecue, insert Regulator/Valve
into end of burner (A)
Notch in Regulator/Valve MUST engage dimple in end of
burner.
2. Once Regulator/Valve has completely engaged burner, turn
Regulator/Valve clockwise (B) to lock in position with knob
pointing as shown (C).
3. To remove reverse steps.
A
Red notch
Page 6
B
Dimple
Full engagement
C
Leak Testing ( 465g. Disposable)
• During leak test, keep barbecue away from open flames or sparks
and do not smoke. Barbecue must be leak tested outdoors in a
well ventilated area.
• Leak test must be repeated each time gas container is replaced
or after storage.
Materials needed include clean paint brush and 50/50 soap and
water solution. Use mild soap and water.
household cleaning agents.
result.
1. Be sure control knob on regulator is in
2. Brush soapy solution onto
and regulator at (A) .
3. Brush soapy solution onto
threads and regulator, and burner tube and orifice at
If growing bubbles appear, there is a leak. Retighten
connections and repeat
steps 1 , 2, and 3.
B
If you cannot stop a leak, remove gas container from regulator
and check for damaged threads, dirt and debris on regulator and
gas container. Also check to see if anything is obstructing flow of
gas at regulator and gas container openings. Remove any
obstruction that may be found and repeat leak test. IF threads
are damaged on either regulator or gas container, replace.
If there is a leak from your appliance (smell of gas) and you
cannot stop the gas flow, remove the appliance to a well-
ventilated location away from any ignition source. Check for
leaks using soapy water. Do not try to detect leaks using a
flame.
Call OZtrail Leisure Porducts at (07) 3279 1800 for
replacement parts to correct leaks.
.
IMPORTANT: REMOVE PROPANE CONTAINER FROM
REGULATOR/VALVE WHEN NOT IN USE.
Propane Container Removal:
1. Turn regulator control knob to
2. Allow barbecue to cool.
3. Remove the propane container by turning counter-clockwise until
disengaged from the Regulator/Valve.
4. Install cap on container. Cap should be kept on container when
not in use to prevent dirt and debris from entering Regulator/Valve.
IMPORTANT!
Do not use
Damage to components can
position.
connection between gas container
connection between regulator pipe
(B)
A
.
.