Char-Broil GRILL2GO X200 Product Manual page 15

Troubleshooting (continued)
Problem Possible Cause
Burner(s) will not light
•Push-button sticks at bottom.
using ignitor.
•Sparking between ignitor and electrode.
Burner(s) will not •See "GAS ISSUES:" on previous page.
match light.
•Match will not reach using match holder.
•Improper method of match-lighting.
Low flame, drop in gas
•Out of gas.
flow.
Flames blow out. •High or gusting winds.
•Low on LP gas.
Flare-up.
•Grease buildup.
•Excessive fat in meat.
•Excessive cooking temperature.
Persistent grease fire. •Grease trapped by food buildup in
Flashback... •Burner and/or burner tubes are blocked.
(fire in burner tube(s)).
firebox
Prevention/Solution
•Replace ignitor.
•Inspect wire insulation and proper connection. Replace ignitor wire /
electrode assembly if insulation is broken.
•Use long-stem match (fireplace match).
•See "Match-Lighting" section of Use and Care.
•Check for gas in LP container.
•Turn front of barbecue to face wind or increase flame height.
•Replace LP container.
•Clean heat tent / burner and inside of barbecue/firebox.
•Trim fat from meat before barbecuing.
•Adjust (lower) temperature accordingly.
•Turn regulator control knob to OFF. Turn gas off at LP container. Leave
lid in closed position and let fire burn out. After barbecue cools, remove
and clean all parts.
•Turn knob to OFF. Clean burner and/or burner tubes. See burner
cleaning section of Use and Care.
Page 15