Figure - Harmar Mobility HELIX Installation & Service Manual

INSTALLATION
12. Supports: Re-check angles, then, using the appropriate hardware, attach the supports to the stairs,
starting at a corner. Firmly set the supports to the rail with set screw. Repeat the process at the other
corners; re-check angles. Complete all other legs. [Figures 10-1, 10-2]
NOTE: When on carpet tighten down the floating legs first, then tighten the set screw on them.
Loosen the set screws on the legs you were using for support and tighten them to the floor. Tighten
the set screw.
13. Charging Station
Install charging station on rail. [Figure 10-3]
Alignment
Align charging stations. Pay attention to the
charging contacts where the drive unit meets
the station. They should apply pressure to the
charging strips on the chassis. Adjust as needed.
The spring loaded contacts should compress
about 1/4 of an inch. [Figures 10-5, 10-6]
Route red and black wires through hole provided
in rail by charging station. Use provided gromnet
to protect wire.
Determine which end has the AC power for the
power supply. Connect the power supply with
the provided connector which has a red and
black wire, to the red and black wires. Using the
provided terminals attach the charge wire to the
wires in the rail. [Figure 10-7]
NOTE: The power supply charger needs to be placed out of the weather elements to be protected.
10

Figure 10-1

Figure 10-3
| www.harmar.com | 800-833-0478
Align with chassis [Figure 10-4]
Top and bottom.
Figure 10-5
Battery
Charger
Figure 10-7
Figure 10-2
Figure 10-4
Figure 10-6
Red
White + Red +
Black - Black
© 2018 Harmar Mobility, LLC • All Rights Reserved
+
-
+
-