Table of Contents
Advertisement
2.2 Overview – 2 (System Settings)
1) Timer settings and recovery time (System settings => Timer setting)
Mode
Energy Saver 1
Default: Off
Energy Saver
Mode 2
(Sleep Mode)
Slide 176
The user can set these timers with Menu key
: User Tool key > Admin. Tools > Energy Saver mode (MF)
: Menu key > System > Energy Saver mode (Printer)
We recommend that the default settings should be kept.
If the customer requests that these settings should be changed, please
explain that their energy costs could increase, and that they should
consider the effects on the environment of extra energy use.
If it is necessary to change the settings, please try to make sure that the
Auto Off timer is not too long. Try with a shorter setting first, such as 30
minutes, then go to a longer one (such as 60 minutes) if the customer is not
satisfied.
If the timers are all set to the maximum value, the machine will not begin
saving energy until 60 minutes has expired after the last job. This means
that after the customer has finished using the machine for the day, energy
will be consumed that could otherwise be saved.
If you change the settings, the energy consumed can be measured using
SP8941, as explained later in this presentation.
2. Energy Saving
Power
Consump.
Warm-up
Operation Mode
Ready Mode
Energy Saver Mode 1
Energy Saver mode
1 Timer
30sec.
Energy Saver mode 2 (Sleep Mode)
Plug-in
Auto Off Timer
After 240min.
Timer
1 - 240min.
from last job
starts
Timer
Defult
Enegy saver mode 1 Timer
30 sec.
Energy saver mode 2 Timer
10 min.
176
PE-MF3/PE-P2 Training
Time
Setting range
Recovery time
Cannot be adjusted.10 sec.
1 to 240 min.
30 sec.
Advertisement
Table of Contents
