Mira SELECT Installation & User Manual page 13

7. Secure the securing brackets to the mixing
valve with the bracket screws.
Important! Make sure that the correct holes
are used, otherwise the backplate cannot be
fitted.
Note! The securing brackets can be rotated
for suitable fixing points.
Countersunk Fixing Hole
Rotate for Suitable
Fixing Point
Backplate securing
hole
Note! Securing Brackets shown
in preferred position to allow the
Compression Nuts to be tightened.
8. Making sure that the mixing valve is level, mark
the positions for the countersunk fixing holes
on the wall.
9. For solid walls, drill two Ø6 mm holes for the
wall plugs.
Caution! Do not drill into pipes or electrical
cables buried in the wall.
10. Fit the wall plugs provided and secure the
mixing valve to the wall with the screws
supplied.
Note! For stud partition installations, alternative
fixings may be required (not supplied).
11. Connect the hot and cold supply pipes and
tighten the compression nuts.
Caution! Make sure that the olives are fitted
and all pipework is flushed through before
connecting to the mixing valve.
Rear Fixing Point
13
12.Connect the outlet pipework and install the
RAC assembly or BIR assembly, before
continuing with the installation of the mixing
valve.
RAC assembly, go to section: 'Installation,
RAC Assembly'.
BIR assembly - refer to your shower fittings
installation and user guide and follow
instructions 13 to 19.
Hot
13.Secure the building-in shroud to the mixing
valve using the two shroud screws removed
earlier.
14. Using the building-in shroud as a guide, finish
the wall, e.g. tiles.
Caution! Make sure that the finished wall is
within the maximum and minimum limits and to
an even depth (no greater than 2 mm variation)
or the control components will not fit correctly.
Min Finished
Wall Surface
Max Finished
Wall Surface
15. Remove the two shroud screws (retain for later
use) and remove the building-in shroud.
16. Fit the concealing plate and control assembly.
Refer to section: 'Control Assembly'.
Outlet Pipe
to Fittings
Screws
Cold
Finished Wall
F9802
Min
Max