Checking The Delivery Contents; Installing The Appliance; Connecting The Appliance; Switching On The Appliance For The First Time - Melitta Caffeo Barista T Smart Operating Instructions Manual

3.2 Checking the delivery
contents
Check the completeness of delivery using
the following list. If parts are missing,
contact your retailer.
ū Coffee spoon with screw-in aid for the
water filter
ū Plastic milk container or thermal milk
container each with milk hose or just
the milk hose (depending on the
model)
ū Stainless steel plate for cup tray
(depending on the model)
ū Coffee system cleaning agent
ū Milk system cleaning agent
ū Water filter
ū Test strip for determining the water
hardness.

3.3 Installing the appliance

Observe the following instructions:
ū Do not install the appliance in damp
rooms.
ū Install the appliance on a stable, flat
and dry surface.
ū Do not install the appliance in the vicin-
ity of sinks or the like.
ū Do not install the appliance on hot
surfaces.
ū Install the appliance at a sufficient
distance (approx. 10 cm) from the wall
and other objects. The space above the
appliance should be at least 20 cm.
ū Route the power cable so it cannot be
damaged by edges or hot surfaces.

3.4 Connecting the appliance

Observe the following instructions:
ū Check that the supply voltage matches
the operating voltage specified in
the technical data (see the table,
page 62).
ū Only connect the appliance to a prop-
erly installed earthing contact socket. If
in doubt, consult a specialist electrician.
ū The socket must have a fuse of at least
10 A.
3.5 Switching on the appliance
for the first time
During initial start-up, the language, the
time and the water hardness can be set.
The settings can be changed at a later
point in time (see chapter 8, page 53
and chapter 9.8, page 60).
Use the enclosed test strip to determine
the water hardness. Observe the instruc-
tions on the test strip packaging and in the
table Water hardness range, page 62.
Information
We recommend pouring away the first two
cups of coffee after initial start-up.
Requirement: The appliance has been
installed and connected.
1. Place a vessel beneath the outlet.
2. Press the ON/OFF button.
» The welcome display appears on the
appliance.
» The request to carry out the setup
appears on the display: Please set up
the machine.
» The "menu/ok" button flashes.
3. Confirm with "menu/ok".
» The Language menu appears.
4. Select your language with the arrow
buttons. Confirm with
"menu/ok".
» The Clock menu appears.
5. Select the hour and the minutes with
the arrow buttons. Confirm each set-
ting with "menu/ok".
» The Water hardness menu appears.
6. Select the determined water hardness
range with the arrow buttons or con-
firm the default value with "menu/ok".
» The request Please refill and insert
water tank appears.
7. Remove the water tank. Rinse out the
water tank with clean water. Fill the
water tank with fresh water and insert
it.
» The appliance heats up and per-
forms automatic rinsing.
First steps
41