Compaq AlphaServer GS140 Getting Started page 53

Example 4–1 Check Configuration from Primary Console (Continued)
C8 PCI connected to kftha1
0+ SIO
3+ VGA
6+ QLogic ISP1040B
7+ QLogic ISP1040B
8+ DECchip 21041-AA
9+ DECchip 21140-AA
A+ KZPSA
B+ Mylex DAC960
Controllers on SIO
0+ DECchip 21040-AA
1+ FLOPPY
2+ KBD
3+ MOUSE
6+ TOY
EISA connected to pci3 through sio2
Use the show config command to ensure that the correct CPU modules are
present and that there are sufficient DWLPB PCI card cages with KFE72-DA
adapters for the desired number of partitions.
After power-up completes, issue the show config command from the
console prompt.
The processors are KN7CG processors.
Ensure that there are enough PCI card cages with KFE72-EA and KFE72-
DA adapters attached. Note that the listing for the C1 hose attached to the
KFTIA has a VGA monitor card, indicating that this is a KFE72-EA. The
SIO listings for the DWLPBs connected to slots 7 and 6 show modules
consistent with KFE72-DAs.
pci3
4828086 0015 sio2
D1011 0022 vga1
10201077 0005 isp6
10201077 0005 isp7
141011 0021 tulip6
91011 0022 tulip7
81011 0000 kzpsa1
11069 0002 dac3
sio2
21011 0024 tulip5
2 0000 floppy2
3 0000 kbd2
4 0000 mouse2
7 0000 toy2
eisa2
Setting Up, Initializing, and Booting Logical Partitions 4-5