Jump To End - Mitsubishi MELSEC-Q Series Programming Manual

GOEND
6.5.2

Jump to END

GOEND
Structured ladder
GOEND
EN ENO
Input argument, EN:
Output argument, ENO:
Setting
data
−
Function
Jumps to the FEND instruction in the same program file.
Operation Error
In any of the following cases, an operation error occurs, the error flag (SM0) is turned ON, and
the corresponding error code is stored to SD0.
• The GOEND instruction has been executed after the execution of the CALL instruction
prior to the execution of the RET instruction.
• The GOEND instruction has been executed after the execution of the FOR instruction,
and prior to the execution of the NEXT instruction.
• The GOEND instruction has been executed during an interrupt program prior to the
execution of the IRET instruction.
• The GOEND instruction was executed within the CHKCIR to CHKEND instruction loop.
6.5 Program Branch Instructions
6-140
6.5.2 Jump to END
ST
ENO:=
GOEND
Executing condition
Execution result
Internal device
R, ZR
Bit Word
GOEND
(EN);
: Bit
: Bit
J \
U \G
Bit Word
−
GOEND
High
Universal
Performance
UD
indicates the following instruction.
Zn Constant Others
(Error code: 4211)
(Error code: 4200)
(Error code: 4221)
(Error code: 4230)