Installing The Gecko Sma-Hr - Gecko Compact Product User Manual

Seismographs, accelerographs recorders, vibration monitors
Hide thumbs Also See for Compact:
Table of Contents

Advertisement

Installing the Gecko SMA-HR

You'll need a hammer drill, a hammer, and the included installation kit.
1
1.
Using the supplied 10mm masonry bit and your hammer drill, make a vertical hole for
the drop-in anchor.
Tip: measure the depth of the anchor and place some tape on the drill bit so you know how deep to drill
2.
Insert anchor thread-side up into hole. Gently tap with hammer until flush with surface
3.
Insert the tapered end of the anchor setting tool into the anchor.
4.
By tapping down the embedded spreader, the anchor will bite into the hole. A few firm
taps of your hammer will be enough to punch the spreader to the bottom of the anchor.
5.
Screw the supplied 8mm threaded rod into the anchor. After tightening, ensure the rod
cannot be pulled out of the ground by hand.
6.
Using the central hole in the Gecko SMA-HR, slide the unit over the threaded rod.
10
6
30
8
3

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

TremorPrismRuggedSmaSma-hrBlast

Table of Contents