2) Rear Brake System
Clean the dissembled components and visually check the followings:
- Wear, rust and damage on the cylinder and piston
- Damage, crack and wear on cylinder body and guide pin
- Uneven wear and oil contamination on pad
- Damage and tear on boot
- Scratch and bending on disc plate
▶
Pad Thickness
▶
Brake Disc Thickness
1.
Remove the rear tire.
2.
Measure the pad thickness and replace it if it
is below the wear limit.
New pad
10 mm
Replace the brake pads at both sides as a
set.
1.
Measure the disc thickness at over ten
points.
2.
If any of measured points is below the wear
limit, replace the brake disc with new one.
New pad
20.0 mm
08-11
4850-03
Wear limit
2 mm
Wear limit
18.4 mm