Before First Use - Electrolux EHG313BD User Manual

8 electrolux.com.au

BEFORE FIRST USE

INSTALLATION
• An authorised person must install this appliance and
MUST provide a Certificate of Compliance.
This certificate should be retained along with
purchase information.
• Before using the appliance, ensure that all packing
materials are removed from the appliance.
• In order to avoid any potential hazard, the installation
instructions in this booklet, and any labels on the
appliance must be followed.
• Ensure that all specified vents, openings and air
spaces are not blocked.
• Where the appliance is built into a benchtop, the
benchtop material must be capable of withstanding
85°C.
• Ensure that the duplicate rating label (in the
instruction pack) is attached to a readily accessible
adjacent surface, so that the cooktop can be easily
identified in the case of a service call.
SERVICING
• Servicing MUST only be carried out by authorised
personnel.
• To maintain safe operation, it is recommended that
the product be inspected every five years by an
authorised service person.
• If the supply cord is damaged, it must be replaced
by the manufacturer, its service agent or similarly
qualified persons in order to avoid a hazard.
CLEANING
• Always ensure the appliance is turned off before
cleaning.
• This appliance contains aluminium fittings.
Do not use caustic based cleaners.
• Do not use steam cleaners as this may cause
moisture build up on electrical components.
• Always clean the appliance immediately after
any food spillage.
• Do not place any components in a dishwasher.
• Refer to page 10 for care and cleaning instructions for
stainless/ ceramic hob panel.
CAUTION
• Do not place burners or trivets in a dishwasher.
CONTROLS
Each burner is controlled by a control knob. The markings
on the control panel indicate which burner the knob
controls, and the setting for that burner (see Figure 4).
LIGHTING BURNERS
Electronic ignition: These cooktops are fitted with
mains powered ignition. When the appliance has been
connected and the power is on, depressing any knob will
release sparks to all burners.