Cd Changer - Sony MEX-DV1100 Operating Instructions Manual

Selecting an auxiliary device
1 Press (SRC) repeatedly until "AUX" appears
on the main unit.
2 Press (MODE) to select "FRONT-IN" or
"REAR-IN."
Operate by the auxiliary device itself.
Adjusting the volume level
Be sure to adjust the volume of each connected
device before playback.
1 Turn down the volume on the unit.
2 Press (SRC) repeatedly until "AUX" appears
on the main unit.
If two auxiliary devices are connected, select
the device to adjust its volume by pressing
(MODE).
3 Start playback of the auxiliary device at a
moderate volume.
4 Set your usual listening volume on the unit.
5 Press (SYSTEM SETUP).
6 Press M/m to select "AUX-LVL," then press
(ENTER).
7 Press M/m to adjust the input level.
The input level is adjustable in single steps,
between –6 and +18.
8 Press (ENTER).
The setting is complete.
With the main unit
Press (SOURCE) instead of (SRC), rotate the volume
control dial instead of pressing M/m.
46

CD changer

M/m
Z Z
X
SRC
Selecting the changer
1 Press (SRC) repeatedly until "CDC" appears.
2 Press (MODE) repeatedly until the desired
changer appears.
Unit number
Disc number
Playback starts.
With the main unit
Press (SOURCE) instead of (SRC).
Skipping albums and discs
1 During playback, press M/m.
To skip Press M/m
album and release (hold for a
moment).
album within 2 seconds of first
continuously releasing.
discs repeatedly.
discs then, press again within 2
continuously seconds and hold.
With the main unit
Use (3)/(4) (ALBUM –/+) instead of M/m.
ENTER
PL
MODE