Zoom F4 Supplementary Manual page 6

Input limiter
▶ Continue to one of the following procedures.
Using the limiter ................................................................P .06
Setting the type .................................................................P .07
Setting the threshold .........................................................P .08
Setting the attack time.......................................................P .08
Setting the release time ....................................................P .09
Setting the target level ......................................................P .10
On (Normal)
Before limiter
On (Advanced)
Before limiter
06
(continued)
Peak might remain
After limiter
Sudden peaks are
suppressed by detecting
maximum levels in advance
After limiter
Using the limiter
5.
Use e to select
press E .
6.
Use e to select the setting,
and press e.
threshold
Setting value
Off This disables the limiter.
On (Normal) This applies an ordinary limiter. The ratio is 20:1.
By detecting the maximum level in advance, this optimized
limiter prevents distortion even more than ordinary limiter
On (Advanced)
operation. The ratio is ∞:1, providing increased internal
headroom.
target
level NOTE
When set to On (Advanced), the input latency of the F
increases 1 ms. When monitoring sounds being recorded with a
mic in real-time, increased latency can cause interference between
sound transmitted through the air from the source and the delayed
monitored sound, possibly making accurate monitoring of the
sounds difficult.
On/Off
, and
Explanation