Setting Signals Sent To The Output Jacks (Routing) - Zoom F4 Supplementary Manual

Setting signals sent to the output jacks (Routing)

In Version 3.0, advanced limiter was added. You can set the type of signal sent to the headphone output, MAIN OUT and SUB
OUT to either prefader or postfader for each track.
1.
Press m.
2.
Use e to select OUTPUT,
and press E.
3.
Use e to select Routing,
and press E.
▶ Continue to one of the following procedures.
Setting signals sent to the headphone output ................P .13
Setting signals sent to the MAIN OUT .............................P .15
Setting signals sent to the SUB OUT ...............................P .16
Setting signals sent to the headphone output
4.
Use e to select Headphone
Routing, and press E.
5.
Use e to select the tracks/outputs for routing,
and press E.
Mid-side
stereo
monitoring
Press to cycle through settings
• Change tracks 1–6 to postfader (cancel others)
• Change L/R to postfader (cancel others)
• Change M1/M2 to postfader (cancel others)
• Change S1/S2 to postfader (cancel others) (cancel MS)
• Chamge track U1-U4 to postfader (cancel other) (cancel MS)
Press to set tracks 1–6 to prefader (cancel MS)
F
Multi Track Field Recorder
Prefader selected
Postfader selected
Off
Tracks routed to the left
headphone channel
Tracks routed to the right
headphone channel
Mono mix
Clear all settings
13