Zoom F4 Supplementary Manual page 18

Correcting timecode errors after the power has been turned off
7.
Calibration completes.
8.
To cancel calibration, press
m, and use e to select
Yes, and press E .
NOTE
• After calibrating once, the result will be retained.
• If the F is moved to and used in an extremely hot or cold loca-
tion, timecode precision could change slightly when the power is
turned off. In such cases, we recommend calibrating it again.
• Calibration is not possible when AIF with Rec is set to On.
• Calibration is only possible when Start TC mode is set to RTC.
• Calibration is not possible when an
18
is connected.
(continued)