ZIEHL UFR1001E Quick Manual

Temperature Relays and MINIKA®
Quick Guide UFR1001E
- NA-protection according to VDE-AR-N 4105:2011+2018-11, power generators at the low
voltage grid, TAR medium voltage VDE-AR-N 4110:2018-11
- for use in power generators at the medium voltage grid according to BDEW
- with selectable vector shift detection and Rate of Change of Frequency (ROCOF,df/dt)
Detailed operating manual see:
New, Firmware 0-10: default setting program 2 for low voltage VDE-AR-N 4105:2018-11
4 new programs (11-14) for medium voltage according to 4110:2018-11, new test mode
(display of the firmware function
General Notes
Compliance with the following instructions is mandatory to ensure the functionality and safety of the
product. If the following instructions given especially but not limited for general safety, transport, storage,
mounting, operating conditions, start-up and disposal / recycling are not observed, the product may not
operate safely and may cause a hazard to the life and limb of users and third parties.
Deviations from the following requirements may therefore lead both to the loss of the statutory material
defect liability rights and to the liability of the buyer for the product that has become unsafe due to the
deviation from the specifications.
Operating controls
1 Test button
Press Display
shortly
without a button is pressed = go back to the normal mode)
2 LEDs Frequency / voltage, above / below threshold (red)
AL AL M
ON, or
8 8 8
AL
Flashing,
8 88
3 LED Vektor shift (VSR, red)
ON, AL
8 8
AL
Flashing,
8 8
4 LEDs Relay status (yellow)
OFF Relays de-energized
5 Digital display 4-digit (red)
Depending on program, display of current voltage, frequency, vector shift, average value
Display of alarm message
6 LED Time (yellow)
ON A time is displayed
7 Backmost decimal point (red)
OFF Display mode
Lightning Menu mode
Flashing Configuration mode
UFR1001E 12420-0751-13
Mains Monitoring Digital Panelmeters MINIPAN®
https://www.ziehl.com/en/products/?view=detail&detail=54
→ 8fnr
8Info8
test-menu: Relay K1 (8tst18) or K2 (8tst28) can be tested independently. (3min
Above / below threshold
8
AL M
or OFF-delay
8 8
Threshold value for vector shift exceeded
dof
OFF-delay
8 8
AL aL M
,
8 8 8
Switching Relays and Controls
or press "Set" for >10 s)
8
dof
active
8 8
active
ON Relays energized
Display of error with error code e.g.
8
Seite 1 / 8
ZIEHL industrie – elektronik GmbH + Co KG
Daimlerstr.13, 74523 Schwäbisch Hall, Germany
+ 49 791 504-0, info@ziehl.de,
Measuring Transducers Grid- and Plant Protection
updated: 2019-04-24/Ba
from Firmware: 0-10
Err9
8 8
www.ziehl.de
www.ziehl.de