Stopping The System - ProFire PF3100 Quick User Manual

Start Using Ignition Switch
The ignition switch can be used to start an individual burner, as there is one ignition switch for each burner
in the system. It is located on the right side of each enclosure containing a BMS controller card.
Ensure that there are no alerts pertaining to the desired burner, then turn its ignition switch to the
position. Hold it until the status light turns green (approximately 1 second) to begin the ignition sequence
for that specific burner.
The ignition switch cannot be used to start multiple burners at once.
Other Methods
The PF3100 can also be started via Modbus, or remotely using the BMS start contact.

Stopping the System

Using the Ignition Switch
Turn any ignition switch on an appliance to the
appliance.
Using the BMS ESD Contact
The ESD contact can be wired to an appropriately rated emergency shutdown switch that can be used to
shut down the entire appliance.
Using the UI STOP Button
Press the STOP
and press OK. The selected appliance(s) or controller(s) will then shut down immediately.
Note: the STOP function on the UI is NOT safety rated.
disconnected from the network, or otherwise incapacitated.
PROFIRE
1.855.776.3473
solutions@profireenergy.com
button to bring up the STOP
STOP position to immediately shut down the entire
menu. Use the arrow keys to navigate to the desired option
This function may be unavailable if the UI is offline,
PF3100 Quick User Guide
Ignite
Page 6 of 13