Important Safety Information - ProFire PF3100 Series Product Manual

•
Using a calibrated dry block, insert the attached thermocouple into the dry block, and using the
PF3100 system, monitor the measured temperature to ensure the temperature read is accurate
(within 2°C).
•
Ensure the thermocouple is a non-grounded type K thermocouple.
•
Short all inputs and monitor the temperatures using the PF3100. Measured temperature with
short should be near ambient temperature.
•
Ensure all shorts are removed and re-wire the proper temperature element.
Cleaning
If the card becomes dirty it can be cleaned with compressed air. Do NOT use solvents, cleaners, or liquids to clean
the board. Caution must be exercised when cleaning the board in order to prevent damage from ESD (electrostatic
discharge).
Replacement Parts
Please contact PROFIRE should any replacement parts be required.

9. Important Safety Information

Before installing the PF3100 Thermocouple card, please review the list of warnings below. Product use in a
manner not specified by PROFIRE is not recommended. Failure to observe the following warnings may result in
death, electrocution, property damage, product damage, product damage, government fines, or malfunction of
the product itself.
WARNING: Explosion Hazard
➢
Do not disconnect while circuit is live unless area is known to be non-hazardous or equivalent.
➢
Substitution of components may impair suitability for specified zones.
➢
Do not service unless the area is known to be non-hazardous.
➢
Do not open when energized.
➢
Installation and use must conform to the directions in this guide.
➢
System must be properly connected to earth-ground for effective operation of flame detection circuitry.
Installation Warnings
➢
Ensure that the PF3100 enclosures are securely closed each time after opening the enclosure. This protects the
internal circuitry from moisture damage and other environmental concerns. Moisture damage is not covered by
the product warranty.
➢
Do not drill holes in or otherwise modify the TLX enclosure. Any such modifications will compromise suitability
for Class I, Div 1/Zone 1.
➢
The probe assembly is suitable for use in Div 1/Zone 1 but must be installed using appropriate fittings and an
appropriately rated Thermowell in order to maintain the Div 1/Zone 1 rating of the enclosure. Please refer to
the Canadian Electrical Code or National Electrical Code as applicable for details.
➢
Never install the probe directly into a bath or pressure vessel. Always use an appropriately rated Thermowell.
➢
This card will NOT function with grounded thermocouples.
PROFIRE
1.855.776.3473
solutions@profireenergy.com
PF3100 Thermocouple Card Product Manual
Page 10 of 11