Important Safety Information - ProFire PF3100 Series Product Manual

➢ A qualified technician should perform any tests necessary to confirm that the equipment is still in a safe
condition.
Cleaning
If the card becomes dirty it can be cleaned with compressed air. Do NOT use solvents, cleaners, or liquids to clean
the board. Caution must be exercised when cleaning the board in order to prevent damage from ESD (electrostatic
discharge).
Replacement Parts
Please contact PROFIRE should any replacement parts be required.

9. Important Safety Information

Before installing the PF3100 Modbus card, please review the list of warnings below. Product use in a manner not
specified by PROFIRE is not recommended. Failure to observe the following warnings may result in death,
electrocution, property damage, product damage, product damage, government fines, or malfunction of the
product itself.
WARNING: Explosion Hazard
➢
Do not disconnect while circuit is live unless area is known to be non-hazardous or equivalent.
➢
Substitution of components may impair suitability for specified zones.
➢
Do not service unless the area is known to be non-hazardous.
➢
Do not open when energized.
➢
Installation and use must conform to the directions in this guide.
➢
System must be properly connected to earth-ground for effective operation of flame detection circuitry.
Installation Warnings
➢
Ensure that the PF3100 enclosures are securely closed each time after opening the enclosure. This protects
the internal circuitry from moisture damage and other environmental concerns. Moisture damage is not
covered by the product warranty.
➢
Do not connect wires or handle the device when powered.
➢
Properly fuse the board according to local codes.
➢
Do not disassemble or modify the board in any way. The board is not field repairable and must be sent back to
PROFIRE for replacement if damaged.
PROFIRE
1.855.776.3473
solutions@profireenergy.com
PF3100 IO Modbus Card Product Manual
Page 9 of 10