Table of Contents
Advertisement
Chapter 2
Installing the Device
Figure 7: Terminal Block Wiring – Single DC Power Supply Inputs
1. Positive Terminal 2. Negative Terminal 3. Surge Ground Terminal 4. Braided Ground Cable
3.
Connect the negative wire from the power source to the negative terminal on the terminal block.
4.
Using a braided wire or other appropriate grounding wire, connect the surge ground terminal to the chassis
ground connection. The surge ground terminal is used as the ground conductor for all surge and transient
suppression circuitry internal to the unit.
5.
Connect the ground terminal on the power source to the chassis ground terminal on the device.
6.
If a redundant power source is required, repeat
Section 2.7
Connecting to the Device
The following describes the various methods for accessing the ROS console and Web interfaces on the device. For
more detailed instructions, refer to the RUGGEDCOM ROS User Guide for the RUGGEDCOM RS900GF.
Serial Console Port
Connect a PC or terminal directly to the serial console port to access the boot-time control and RUGGEDCOM ROS
console interface.
IMPORTANT!
The serial console port is intended to be used only as a temporary connection during initial
configuration or troubleshooting, and should only be used in a safe area (as defined by IEC 60079-0,
Edition 6.0).
12
2
1
3
Step 1
to
Step 5
using the second terminal.
RUGGEDCOM RS900GF
Installation Guide
4
Connecting to the Device
Advertisement
Table of Contents
