Table of Contents
Advertisement
Chapter 2
Installing the Device
• Equipment must be installed according to applicable local wiring codes and standards.
CONTENTS
•
Section 2.6.1, "Connecting High AC/DC Power"
•
Section 2.6.2, "Connecting Low DC Power"
Section 2.6.1
Connecting High AC/DC Power
To connect a high AC/DC power supply to the device, do the following:
CAUTION!
Electrical hazard – risk of damage to equipment. Do not connect AC power cables to terminals for DC
power. Damage to the power supply may occur.
CAUTION!
Electrical hazard – risk of damage to equipment. Before testing the dielectric strength (HIPOT) in the
field, remove the braided ground cable connected to the surge ground terminal and chassis ground.
This cable connects transient suppression circuitry to chassis ground and must be removed to avoid
damage to transient suppression circuitry during testing.
1.
Connect the positive wire from the power source to the positive/live (+/L) terminal on the terminal block.
10
RUGGEDCOM RS900GF
Installation Guide
Connecting High AC/DC Power
Advertisement
Table of Contents
