Right Handlebar Switches; Stop Position - Triumph Thruxton TFC 2019 Owner's Handbook Manual

General Information
There is a transponder within the
ignition keys to turn off the engine
immobilizer. To
immobilizer functions correctly, always
have only one of the ignition keys near
the ignition switch. Having two ignition
keys near the switch may interrupt the
signal between the transponder and
the engine immobilizer. In this situation
the engine immobilizer will remain active
until one of the ignition keys is removed.
Always get replacement keys from
your authorized
Replacement keys must be 'paired' with
the motorcycle's immobilizer by your
authorized Triumph dealer.
38
make sure the
Triumph dealer.

Right Handlebar Switches

2
3
4
1. Engine start/stop switch
2.

STOP position

3. RUN position
4. START position
5. Hazard warning light switch
STOP Position
The STOP position is for emergency use.
If an emergency arises which requires
the engine to be stopped, move the
engine start/stop switch to the STOP
position.
Do not leave the ignition switch in
the ON position unless the engine is
running as this may cause damage
to electrical components and will
discharge the battery.
Note
Although the engine stop switch stops
the engine, it does not turn off all
the electrical circuits and may cause
difficulty in restarting the engine due
to a discharged battery. Ordinarily, only
the ignition switch should be used to
stop the engine.
1
5
Caution