Makita LH1040 Technical Information page 7

R
epair
< 5 > Removing blade case section
11. Put the removed blade case section on the turn base of arbor press, And set 1R306 "
between the two screwdrivers, inserted in the step of Fig.3-7. See Fig.3-9.
12. Press down 1R306
the screwdrivers can be pulled out from blade case.
No.1R306
Ring Spring Removing Jig
13. Put the removed blade case section on the turn base of arbor press, And set 1R306 "
between the two screwdrivers, inserted in the step of Fig.3-7. See Fig.3-9.
14. Press down 1R306
while holding the blade case section firmly, so that it does not tilt or
15. Slowly lessen the pressure to 1R306
firmly, so that it does not tilt or wobble. See Fig.3-10.
16. Remove spring holder and compression spring 27 from blade case, when the jig gets free from the force
of compression spring. See Fig.3-10.
No.1R306
Ring Spring
Removing Jig
" Ring Spring Removing Jig" with arbor press. So, spring holder is pressed down and
Fig.3-9
" Ring Spring Removing Jig" with arbor press in order to lower spring holder,
Ring Spring Removing Jig", while holding the blade case section
"
Fig.3-10
Arbor press
Screwdriver
Blade case section
wobble.
Slowly lessen the
pressure to the jig.
Spring holder
Compression spring 27
Blade case section
P 7 / 20
Ring Spring Removing Jig"
Ring Spring Removing Jig"