Table of Contents
Advertisement
2 Configuration in DIGSI 4
2.3 Customization of the Allocations
many entries can be deleted or cannot be deleted. Confirm this information with OK:
Fig. 2-14
The identification whether an information is routed on system interface (DNP3 IP) is shown in the columns
Source and Destination, port F, system interface S in the DIGSI configuration matrix.
A cross ('X') in this column indicates the associated information as "routed on system interface"
(see figure 2-13).
Source System Interface
The SIPROTEC object can be controlled via DNP3 IP. This is possible for the following information types (col-
umn Type in configuration matrix):
•
IntSP
•
IntDP
•
SC/DC
•
SF/DF
Destination System Interface
The value of the SIPROTEC object is transmitted to the DNP3 IP master. This is possible for the following in-
formation types:
•
SP
•
DP
•
Out
•
IntSP
•
IntDP
•
MV
•
MVMV
•
PMV
34
Indications for Delete
Internal single-point indication (tagging)
Internal double-point indication (tagging)
Single control/Double control without feedback from process
Single control/Double control with feedback from process
Single-point indication
Double-point indication
Output annunciation
Internal single-point indication (tagging)
Internal double-point indication (tagging)
Measured value
Power meter (metered measurand, source is a measured value)
Pulse (metered measurand, source is a pulsed binary input)
SIPROTEC, Communication Module, Communication Profile
C53000-L2040-C354-1, Edition 02.2012
Advertisement
Table of Contents
