2.3
Customization of the Allocations
✧
Double-click the function Masking I/O (Configuration Matrix) in the dialog Settings acc. to figure 2-11.
The windows Setting Masking I/O opens:
Fig. 2-13
NOTE
Another port instead of port F can be displayed as Source and Destination of the system interface, for exam-
ple, port B for SIPROTEC 4 devices.
NOTE
If you do not want to display all columns and rows in the configuration matrix for the setting of the system in-
terface or for your information, you can minimize these columns and rows by double-clicking the corresponding
button. If you want to enter values to the minimized columns, you can maximize these columns again by dou-
ble-clicking the corresponding button.
✧
Move the cursor in the columns Source and Destination over port F and determine the column assigned
to DNP3 IP (marked in red in figure 2-13).
The used protocol is displayed (text in a yellow box) if you stop for a short while on the letter F.
✧
If necessary, adapt the default routing in the configuration matrix to your SIPROTEC device/installation as
follows. If you do not want to change anything in the DIGSI routing matrix, continue with the section Time
Synchronization.
✧
If you want to delete all default routings to set new default routings, right-click the corresponding port F
or the system interface S in Source or Destination. Then, click the query Delete configurations at Port
F or Delete configurations at System Interface.
A dialog appears with the information that a deletion is not possible or with the confirmation about how
SIPROTEC, Communication Module, Communication Profile
C53000-L2040-C354-1, Edition 02.2012
Port F
Information
DNP3 IP
type
system interface
DIGSI 4 Configuration Matrix with Columns for System Interface Routing
2.3 Customization of the Allocations
Destination
Source
system interface
system interface
2 Configuration in DIGSI 4
Port F
DNP3 IP
system interface
33