Supported And Unsupported Rtc ® 2 Commands - Scanlab RTC 4 Installation And Operation Manual

10.4 Supported and Unsupported
®
RTC 2 Commands
®
The RTC 4 emulates some RTC
compatibility. Though these emulated commands
®
can be used with the RTC
ware should only use the commands described in
chapter 10.
This section also specifies RTC
®
those RTC 2 commands that are neither supported
nor emulated.
The following table provides an overview of
®
emulated RTC 2 commands and unsupported RTC
commands as well as appropriate RTC
ments.
Ctrl Command aut_change
Support status The RTC
Replaced by auto_change (see page 75)
Function same as
Integration Pascal:
C:
Basic:
List Command field_jump
Support status This RTC
Replaced by home_position (see page 89)
Ctrl Command get_rtc2_mode
Support status This RTC
®
Replaced by The RTC
set_laser_mode (see page 108)
Ctrl Command get_rtc2_version
Support status This RTC
Replaced by get_rtc_version (see page 84)
Ctrl Command get_version
Support status This RTC
Replaced by get_hex_version (see page 83)
®
RTC 4 PC Interface Board
Rev. 1.3 e
10 Commands And Functions
®
2 commands for
4, new application soft-
®
4 replacements for
®
2
®
4 replace-
® ®
4 emulates this RTC 2 command.
auto_change (see page 75)
procedure aut_change;
void aut_change(void);
sub aut_change()
®
2 command is not supported by the RTC
®
2 command is not supported by the RTC
4 has no need to query the mode, which is now be set via the software command
instead of hardware.
®
2 command is not supported by the RTC
®
2 command is not supported by the RTC
®
4.
®
4.
®
4.
®
4.
125