Section 5: Limit Switch Settings
July 2018
Section 5: Limit Switch Settings
Set Open and Close valve travel and torque limits in the AEE before operating valve in
automatic mode. Travel and torque limits are set using a common screw driver.
NOTE:
If electrical operation is used to move the valve while setting limits, stop movement short
of the desired position and use hand wheel to complete valve travel.
5.0.1
Limit Switch Setting Instructions
1.
Figure 4
8
Insert screwdriver in the Open setting slot shown in Figure 4. Use the hand wheel
to open the valve part way. Note the rotation of the screwdriver.
Operation and Maintenance Manual
E2K-200-0718 Rev. 0
Limit Switch Settings