Table of Contents
Advertisement
1
6
1
For
SNMP Manager IP
sent by typing in the IP Address , press the
2
For
Trap Sending
the SNMP Manager. The trap will continue to be resent only as long as the error condition exists.
For
System UpTime Threshold
3
NOTE: When Trap is On, a trap will be sent if the System UpTime exceeds the threshold value.
4
Activate the Trap by checking the small box opposite
NOTE: When Trap is On, a trap is sent if the SNMP Agent is started.
Deactivate the Trap by un-checking the small box next to SNMP Agent Start
5
Activate the Trap by checking the small box opposite
NOTE: When Trap is On, a trap is sent if the SNMP Agent is stopped.
Deactivate the Trap by un-checking the small box next to SNMP Agent Stop.
6
Check on the small box to enable SNMP Service.
April 22, 2014
2.3.5.3. Understanding the SNMP Configuration Interface
2.3.5.3.1. General
Figure 13
SNMP Configuration [General Settings].
Address, indicate the IP address of the SNMP Manager where traps are to be
Interval, indicate the time interval in seconds after which a trap should be resent to
(days), indicate the threshold time in days.
+
or
-
button to insert multiple SNMP addresses.
SNMP Agent
Start.
SNMP Agent
Stop.
- 33 -
SX-2000A Series with Integrated Media Block/SX-2001A Series
2
.
2. SMS
3
4
5
0
User Manual
Advertisement
Table of Contents
