Mounting The Lens - Sony HDCAM HDW-730 Operation Manual

5-3 Mounting the Lens

Follow the procedure below to mount the lens.
For information about using the lens, refer to the lens manual.
5
1
Push the lens locking lever up and remove the lens mount cap from
the lens mount.
2
Align the center slot in the lens mount with the center pin on the
lens, and insert the lens into the mount.
3
Holding the lens in place, push the lens locking lever down to mount
the lens.
Note
If the lens is not firmly locked, it may come off while the camcorder
is being used. This could cause a serious accident. Make sure the
lens is firmly locked. It is recommended that the lens mount
securing rubber be put on the lens-locking lever as illustrated above.
4
Connect the lens cable to the LENS connector.
5
Secure the lens cable with the cable clamps.
5-14
Chapter 5 Setting Up the Camcorder
Mounting the lens
Lens mount securing
rubber