Adjusting The Audio Level - Sony HDCAM HDW-730 Operation Manual

4-4 Adjusting the Audio Level

Setting the AUDIO SELECT CH-1/CH-2 switches to AUTO
automatically adjusts the input levels of the audio signal to be recorded
in audio channel CH-1 or CH-2 . You can also adjust the audio level
manually.
For the audio level of the signal to be recorded in audio
channel CH-3 or CH-4
Only automatic adjustment of the audio level is available.
When the CH-1/2 / CH-3/4 switch is set to CH-3/4, the audio channel
4
level meters display the level of the audio signals recorded in audio
channels CH-3 and CH-4. You can select the audio input signals to be
recorded for audio channel CH-3 and 4 by using the AUDIO IN CH-3/
CH-4 switches.
Manually adjusting the audio levels of the audio input
from the AUDIO IN CH-1/CH-2 connectors
Follow the procedure described below to adjust the audio levels of the
audio input from the AUDIO IN CH-1/CH-2 connectors, which are to be
recorded in audio channels CH-1 and CH-2.
Note
When 1 and 2 are not displayed under the audio channel level meters,
the CH-1/2/ CH-3/4 switch is set to the CH-3/4 position. Set this switch
to CH-1/2.
At the factory setting, the XLR connection automatic detection mode of
the AUDIO IN CH-1/CH-2 connectors is set to ON. In this case, start the
operation from step 2.
When the XLR connection automatic detection mode is set to OFF, start
the operation from step 1.
You can set the XLR connection automatic detection mode on the VTR
MODE 1 page of the MAINTENANCE menu.
4-28
Chapter 4 Adjustments and Settings for Recording