FOLDING MECHANISM ADJUSTMENT
If the folding mechanism is too loose or too tight, you can adjust it
The adjustments needed are VERY small.
Work sensitively, be patient and you'll get it right!
To Tighten / Loosen
1. The red lever for locking the folding mechanism should be tightened in
a way that the steering rod is firm
2. If the red locking lever is too loose, open it and tighten the folding
system by turning the front tension adjuster approximately 30 degrees
clockwise
3. If the red locking lever is too tight, open it and loosen the folding system
by turning the front tension adjuster approximately 30 degrees anti-
clockwise
4. Test the function until the pressure of the red lever is reasonably hard
and the steering rod is firm
Front tension
adjuster
21
Red locking lever
SERIAL NUMBER
Each INOKIM has a unique serial number
These numbers can provide information that may be
useful later on for insurance claims and in case of loss or theft
Write down the serial number of your OXO scooter.
Keep this information separately and in a safe place!
The number is on the BOTTOM REAR SIDE of the board
20171214016
22