Sony SRX-R815P Operating Instructions Manual page 39

Tip
If the lamp is lit up in yellow or red, check the "Status
- Auditorium" screen's [Solution] message for a
solution.
The solution will be displayed here. Follow
the instructions to deal with the problem.
The projector does not turn on
• Make sure that the chiller provides the proper amount of
water flow (9 to 14 l/min) and water temperature.
If water flow is slow, or water temperature is lower than
5°C (41°F), the projector does not turn on.
• If the lens is not attached, the projector does not turn on.
There is something wrong with the screen/
the screen is too bright
Confirm that the correct screen adjustment data for the
playback content has been called up.
Or check "Calling up Screen Adjustment Data" (page 21).
When operating the screen, a dialog box
appears with a stopped process
confirmation dialog
If this happens, tap [Continue] to continue the process.
If you add a check mark to [Don't ask me again] this dialog
will no longer be displayed.
Screenshot
Caution
If you tap [Stop script], processing will stop and normal
operation may be hindered.
Cannot shut down
Unplug the power cord connected to the rear of the server.
The projector switched to standby during
playback
When the projector switches to standby during playback
due to events such as sudden power outages, use the touch
panel monitor to shut down after screening is complete,
and then restart the system.
If you cannot shut the unit down using the touch panel
monitor, unplug the power cord connected to the rear of the
server, reconnect the cord, and then start the system.
39