Others; Attaching And Removing The Lens; Changing The Lens In Lens Replacement Mode; Changing The Lens While The Power Is Turned Off - Sony SRX-R815P Operating Instructions Manual

Others

Attaching and Removing
the Lens
This section describes how to attach and remove the lens
using illustrations of 2D lenses, however, the steps are the
same for 3D lenses.
You can change the lens in the following conditions.
• In lens replacement mode (Standby state)
• While the power is turned off
Caution
The projector uses a laser as a light source. If the lens is
removed while the projector is lit, the projector is
automatically turned off. You cannot turn on the projector
with the lens removed.
If the lens is changed while the power is turned on and
while the projection system is not in lens replacement
mode, the projector may be damaged.
Changing the Lens in Lens
Replacement Mode
To change the lens while the projector is in the standby
state, use the lens replacement mode in the following steps.
Caution
When removing or attaching the lens in lens replacement
mode, be careful not to touch the exposed electrodes on the
projector's lens connector. Although coming into contact
with the electrodes will not harm you, it may damage the
board's substrate in some rare cases.
1
Tap [Auditorium] in the [Status] tab.
2
Tap [Projector] in the [Control] pane.
The "Projector Control" screen appears.
3
Tap [Start] for [Lens Replacement].
4
Tap [OK] when the "The system will prepare for the
lens replacement. Are you sure?" message appears.
5
Tap [OK] when the "Finish to prepare for the lens
replacement. Please replace the lens." message
appears.
6
Change the lens.
For details, see "Removing the Lens" (page 32) and
"Attaching the Lens" (page 32).
7
After changing the lens, tap [End] for [Lens
Replacement] in the "Projector Control" screen.
8
Tap [OK] when the "The system will initialize the
lens. Are you sure?" message appears.
9
Tap [OK] when the "Finish to initialize the lens.
Please re-load the function." message appears.
10
Load the function.
Changing the Lens while the Power
is Turned Off
1
Shut down the projection system.
2
Move the projector power switch to the off position.
For details, see "Shutting Down the System"
(page 15).
3
Change the lens.
For details, see "Removing the Lens" (page 32) and
"Attaching the Lens" (page 32).
31