Operation; Operating Principles - Miele KM 6324-1 Operating And Installation Instructions

Operating principles

The glass ceramic cooktop is equipped
with electronic sensor controls which
react to finger contact. For safety
reasons, in order to switch the cooktop
on, the On/Off  sensor needs to be
touched for a little longer than the other
sensors.
A tone sounds each time a sensor is
touched.
When the cooktop is switched off, only
the symbols for the On/Off , safety
lock , Stop & Go  and number
sensors are visible. When the cooktop
is switched on, all the other sensors
light up as well.
In order to set or alter a power setting
or the time, the cooking zones and the
timer must be "active". To activate a
cooking zone or the timer, touch the
sensor for selecting the relevant
cooking zone or timer. The relevant
cooking zone or timer display will begin
to flash when touched.
Exception: If only one of the cooking
zones is in operation, you can alter the
power setting without activating the
cooking zone.

Malfunction due to dirty and/or
covered sensor controls.
If the sensor controls are dirty or
covered this could cause them to fail
to react, to activate a function
inadvertently or even to switch the
appliance off automatically (see
"Safety switch-off"). Placing hot
pans on the sensor controls/
indicators can damage the electronic
unit underneath.
Keep the sensor controls and
indicators clean.
Do not place anything over the
sensor control or indicators.
Do not place hot pans over the
sensor controls or indicators.

Operation

27