Miele KM 6310 Operating And Installation Instructions
Ceramic cooktop with induction
Hide thumbs
Also See for KM 6310:
- Operating and installation instructions (72 pages) ,
- Operating and installation instructions (68 pages) ,
- Operating and installation instructions (68 pages)
Related Manuals for Miele KM 6310
Summary of Contents for Miele KM 6310
- Page 1 Operating and Installation instructions Ceramic Cooktop with induction KM 6310 KM 6344 en - CA To prevent accidents and appliance damage, read these instructions before installation or use. M.-Nr. 09 166 590...
-
Page 2: Safety Instructions For Installation
Safety instructions for installation Ensure that the electrical supply The appliance must be installed by cable for the cooktop cannot touch the a qualified professional and floor panel after installation nor be connected to the electric power subject to any mechanical strain. supply by a qualified electrician. - Page 3 Safety instructions for installation Clearance above the cooktop If there is more than one appliance installed below the exhaust hood, each with a different safety clearance, the largest clearance must be used. For an exhaust hood above the cooktop, always use the clearance specified by the hood manufacturer.
- Page 5 Safety instructions for installation Minimum clearance underneath the Protective base cooktop Installation of a protective base under the cooktop is allowed but not required. To ensure proper ventilation of the cooktop, a minimum clearance is A gap of 10 mm at the back is required required between the appliance and an for the power supply cable.
- Page 6 Safety instructions for installation Safety clearance to a wall covering A safety clearance must be maintained between the countertop cut-out and any wall covering to protect it from heat damage. If the covering is made of a combustible material (e.g. wood), a safety clearance e of 50 mm must be maintained between the cut-out and the covering.
- Page 7 Safety instructions for installation Cooktops with frame or Tiled countertop bevelled edges Seal between cooktop and countertop The grouting a and the hatched area below the cooktop frame must be smooth and flat, so that the frame will be level and the sealing strip under the edge of the upper part of the cooktop can provide an adequate seal against the countertop.
-
Page 8: Installation Dimensions
Installation dimensions KM 6310 a Front b Cooktop height c Connection for Miele|home d Electrical box The connection cable (1440 mm long) comes with the cooktop. - Page 9 Installation dimensions KM 6344 a Front b Cooktop height c Connection for Miele|home d Electrical box The connection cable (1440 mm long) comes with the cooktop.
-
Page 10: Installation
Installation Preparing the countertop Inserting the cooktop ^ For the countertop cut-out use the ^ Feed the power supply cable down dimensions given in the illustration. through the countertop cut-out. Observe the safety clearances (see ^ Center the cooktop in the cut-out. Safety instructions for installation). -
Page 11: Electrical Connection
Electrical connection Connection CAUTION: Before installation or The cooktop is ready for connection to servicing, disconnect the power a grounded power supply. supply by either removing the fuses, shutting off the power main or 208/240 V, 60 Hz, 40 A fuse rating. manually "tripping"... -
Page 12: Technical Service, Data Plate
In the event of a fault which you cannot easily fix yourself, please contact the Miele Technical Service Department at the address on the back of this booklet. When contacting Technical Service please quote the serial number and model of the appliance. - Page 14 Alteration rights reserved / 3313 M.-Nr. 09 166 590 / 03 For the most updated manual, visit the Miele web site.