Fxs Configuration - Avaya SR 2330 Task Based Manual

destination-pattern 408.%
port 1/1
# Send all digits
forward-digits all
no shutdown
exit pots

FXS Configuration

To equip the FXS port of the gateway, several parameters need to be configured:
 The Port Location on the gateway
 The Station Number – User ID configured in the SCS for this port
 The Destination pattern – should match the User ID as this is what alerts on
the port.
 Authentication – User ID followed by the SIP Password for the User
configured in SCS

To configure FXS ports on the gateway, type the following commands:
# Configure an FXS phone and register it to the SCS.
# Assuming the following:
# • FXS phone has a telephone number 1000 and connected to 2/1 slot.
# • FXS phone has SIP password 1234 (need to be same password as
configured in the SCS for user 1000)
voice-port 2/1
signal loop-start
no shutdown
station number 1000
exit
dial-peer voice pots 1
destination-pattern 1000
forward-digits all
port 2/1
authentication 1000 1234
no shutdown
register e164
exit
NN40010-551 Issue 1.3 SCS 4.0
AG 2330 Installation Reference
19