Preparing A Power Supply; Using A Battery Pack; Using An Ac Adaptor - Sony DSR-400L Operating Instructions Manual

Preparing a Power Supply

The following power supplies are recommended for the
camcorder.
• BP-GL65/GL95/L60S Lithium-ion Battery Pack
• AC power using the AC-550, AC-DN2, AC-DN10 AC
adaptor

Using a battery pack

When a BP-GL65/GL95/L60S Battery Pack is used, the
camcorder will operate continuously for the time shown
below.
Model name Operating time
BP-GL65 Approx. 180 minutes
BP-GL95 Approx. 300 minutes
BP-L60S Approx. 170 minutes
Before use, charge the battery pack with a charger suitable
for each battery.
For details on charging procedure, refer to the battery
charger operation manual.
Note on using the battery pack
A warm battery pack may not be able to be fully recharged.
To attach the battery pack
1
Press the battery pack against the back of the
camcorder, aligning the line on the side of the battery
pack with the matching line on the camcorder.
Back of the camcorder
2
To detach the battery pack
Notes
• During recording, playback, and loading/unloading a
• Make sure to turn the camcorder off before changing the

Using an AC adaptor

To use the AC-550 AC adaptor
Connect the camcorder to the AC power supply through an
AC-550 AC Adaptor as shown in the following figure, and
turn the POWER switch of the AC-550 on.
BP-GL65/GL95/L60S
Align these lines.
Slide the battery pack down until its "LOCK" arrow
points at the matching line on the camcorder.
tape, be careful never to remove the battery pack.
battery (except when using an AC-550 and an AC-DN2/
DN10 AC adaptor together).
AC Adaptor
AC-550
DC IN
DC output cable (supplied with the AC-550)
"LOCK" arrow
Line on the camcorder
Holding the button in, pull
the battery pack up.
to an AC power source
Power switch on
DC OUT
Preparing a Power Supply
29