Sony DSR-400L Operating Instructions Manual page 129

Symptoms
The equipment connected to the
camcorder via an i.LINK connection
does not react as expected, for
example, the video image does not
appear on its screen.
The camera is not recognized by
the PC that is connected to the
i.LINK connector.
The camera is not controlled by the
PC that is connected to the i.LINK
connector.
Cause
It sometimes takes time for the connected
equipment to recognize the operation.
There is a problem with the software, for
example, it does not support the DVCAM
format, etc.
There is a problem with the software, for
example, it does not support the DVCAM
format, etc.
Remedy
Wait for about 15 seconds. If the connected
equipment still does not react, do the
following.
• Check the i.LINK connection, for example,
by re-inserting the i.LINK cable.
• Turn the power off, and connect the cable
again.
• Change the i.LINK cable.
Install software that supports the DVCAM
format.
Install software that supports the DVCAM
format. Or set the REC TRIGGER switch to
INT.
129
Troubleshooting