Error code list
Error code
Action to take
Er07-***
Turn off the power and consult your Sony
representative.
Er08-***
Or you may be able to eject the cassette using
Er09-***
the following procedure. However, because it
may damage the cassette, any damage is
your responsibility.
When "Warning: SLACK" appears
1 Turn off the camcorder.
This may take about 15 seconds.
2 When the camcorder is turned off, turn it on
again.
3 If the error code disappears, change the
cassette because it may be damaged.
If the error message appears again, turn off
the power and consult your Sony
representative.
When "Warning: CASSETTE" appears
1 Press and hold the STOP button and the
EJECT button at the same time for more
than 3 seconds.
2 When the PLAY button, the REW button,
and the FF button all flash at one time,
release your fingers.
3 If the cassette is ejected, change the
cassette because it may be damaged.
If the error message appears again, turn off
the power and consult your Sony
representative.
Er09-200
Turn off the power and consult your Sony
representative.
Er09-500
Er09-600
Er09-900
Er91-***
Turn off the power and consult your Sony
representative.
Er92-***
When the error code other than the ones listed above is
displayed, turn off the power and consult your Sony
representatives.
Operation/error messages
An operation or error message is displayed in the
operation/error message display area (page 22) in the
viewfinder.
Operation/error
Meaning
message
INTERVAL
Indicates the camcorder is in the
Interval Rec mode.
LOW LIGHT
Appears, depending on the
setting, to indicate the subject
illumination is inadequate.
127
Operation Warnings