Schedule Tab; Set The Controller Clock; Set The Schedule - Generac Power Systems MMG480DI4 Operating Manual

Diesel generator

Hide thumbs

Table Of Contents

Table of Contents

Operation

Press the down arrow until "Timer1 ON Time" is selected and press "ENTER."

Adjust the desired time to start running and press "ENTER."

Press the down arrow until "Timer1Duration" is selected and press "ENTER."

Adjust the time period to the length of time the unit should run after starting, and press "ENTER."

Press "PAGE SELECT" three times to return to the main menu.

Press the "AUTO" button to switch modes to automatic.

10.

Note: The controller must be in Auto mode to run at the programmed time. Use a trickle battery charger or solargizer

to prevent the controller from draining the battery while in Auto mode.

Schedule Tab

The "Schedule" tab shows the current configuration and status of the scheduler, as well as maintenance configuration

status and time remaining until an alarm, electrical trip or shutdown will occur.

Set the Controller Clock

The schedule runs based off the time set in the controller clock. Use the following procedure to set the controller

clock BEFORE setting the schedule:

1. Navigate to the "Maintenance" group and access it by pressing the right arrow "►".

Select the "Time" section by pressing the right arrow "►".

Set the time and date to the correct local time.

Set the Schedule

1. Access the "Scheduler" group by pressing the right arrow "►".

The "Scheduler" group is made up of the "Scheduler Options" and "Scheduler Setup" sections. Each section can be

accessed and exited using the right "►" and left "◄" arrows.

SITE

Return Delay

kVAr

Scheduler Enabled to run Reserved Reserved

Event

Week

Day

Start

Stop

GEN

All

Monday