Download Print this page

Ripmax Easy Street 2 Instruction Manual page 21

Advertisement

Stage
5 6
Schritt
The canopy slots into place locating over the bolts in the firewall
and is retained with a small catch at the rear.
Setzen Sie die Kabinenhaube in die Schlitze und rasten Sie
diese am hinteren Ende ein.
Completed Model / Fer tiges Modell
You are now ready to apply the supplied decals. One at a time,
carefully remove the decals from their backing sheet, apply to
the model relative to diagram below and gently smooth down.
Nun können Sie die mitgelieferten Dekors anbringen.
Ziehen Sie diese einzeln von der Trägerfolie ab und bringen Sie
diese sorgfältig gemäß Zeichnung unten an den entsprechenden
Stellen an.
Balancing / Schwer punkt
The Centre of Gravity (C/G or Balance Point) should be 70-
75mm back from the leading edge of the wing at the root. This
should be measured with the battery pack installed. Support
the completed model under the wing either side of the fuselage
at this point and add weight or adjust the position of the flight
battery in its bay as necessary to achieve a slightly nose down
attitude. A model that is not correctly balanced will not perform
as it should and, at worst, be unstable or unflyable, leading to
damage to the model or injury to yourself or others. Do not miss
out this step in completing your Easy Street II!
Der Schwerpunkt des Modells (C/G oder Balance Point) sollte
bei 70-75mm liegen. Gemessen wird dieses von der Nasenleiste
(Flügelvorderkante) aus nach hinten. Dies muss mit eingebautem
Akku Pack gemessen werden. Stützen Sie das vervollständigte
Modell an der Unterseite des Flügels nahe des
Rumpfes, und geben Gewicht dazu, oder verändern die Position
des Akkus wenn nötig, damit sich die Nase leicht nach unten
neigt. Ein nicht korrekt ausbalanciertes Modell erreicht nicht die
Flugleistung, die es soll. Im schlechtesten Falle wird es unstabil
oder nicht fliegbar. Dadurch kann es zu Schäden am Modell,
oder zu Verletzungen von Ihnen oder anderen kommen. Lassen
Sie diesen Schritt nicht bei der Fertigstellung Ihres Easy Street
II aus!
INSTRUCTIONS / ANLEITUNG
19
70-75mm

Advertisement

loading