Booting The Terastation In Emergency Mode; Cleaning The Dustproof Filter - Buffalo TeraStation 3010 User Manual

Chapter 10 Appendix
• Recover firmware: The TeraStation will be recovered using the firmware on the NAND flash.
• Format drive: The drive will be formatted.
5
The "Confirm Operation" screen will open. Enter the confirmation number, then click OK.
6
Reinstalling the firmware will start. When the firmware is reinstalled, the TeraStation will shut down
automatically. Press the power button to turn it on.
If the error was not recovered from after trying the procedure above, try again from the first step. This time, make
sure you select the checkbox for "Revert the settings to the last boot" and click OK. This will reinstall the firmware by
reverting settings to those from the last boot.

Booting the TeraStation in Emergency Mode

If the TeraStation boots up in emergency mode, depending on your TeraStation model, an "i" symbol is displayed
with the TeraStation icon and "EM" is added to your TeraStation's hostname.
To recover from emergency mode, follow the procedure below.
1
Download the firmware updater from the
2
Extract the downloaded file by double-clicking it and launch the updater.
3
Update the firmware for the TeraStation unit that is currently in emergency mode.
When the "i" symbol and "EM" disappear from the icon and the hostname on NAS Navigator2, the TeraStation is no
longer in emergency mode.
Note: If the TeraStation does not shut down properly due to a power outage or the power cable getting
disconnected while the TeraStation is on, data on the TeraStation may be corrupted when the TeraStation boots in
emergency mode. In such a case, the corrupted data may not be recoverable even if you try the procedure above.

Cleaning the Dustproof Filter

If your TeraStation has a front cover and you are trying to clean the dustproof filter on the front cover, follow the
procedure below.
Buffalo website.
212