Removing And Installing The Ws-F6K-48-Af Inline-Power Daughter Card - Cisco WS-F6K-VPWR-GE Installation Notes

Removing and Installing the WS-F6K-48-AF Inline-Power Daughter Card

Removing and Installing the WS-F6K-48-AF Inline-Power
Daughter Card
The WS-F6K-48-AF inline-power daughter card can be installed only on the following Ethernet
modules:
•
•
•
•
Note The WS-F6K-48-AF inline-power daughter card supports both IEEE 802.3af and the Cisco prestandard.
Removing the WS-F6K-48-AF Inline-Power Daughter Card
To remove the WS-F6K-48-AF inline-power daughter card on the Ethernet module, perform these steps:
Step 1 Loosen and remove the 12 screws and the 3 nuts securing the inline-power daughter card to the module.
(See
Figure 28
Catalyst 6500 Series Power over Ethernet Daughter Cards Field-Upgrade Installation Note
34
WS-X6148-GE-TX
WS-X6148A-GE-TX
WS-X6148A-RJ-45
WS-X6548-GE-TX
Figure 28.)
Removing the Inline-Power Daughter Card Mounting Screws and Nuts
(WS-F6K-48-AF)
Screw
Nut
78-10826-08