Installing The Ethernet Switching Module - Cisco WS-F6K-VPWR-GE Installation Notes

Installing the Ethernet Switching Module

Caution To prevent ESD damage, handle the modules by the carrier edges only.
Caution During this procedure, wear grounding wrist straps to avoid ESD damage to the card.
To reinstall the Ethernet switching module in the chassis, follow these steps:
Verify that the captive installation screws are tightened on all modules installed in the switch chassis.
Step 1
This action ensures that the EMI gaskets on all modules are fully compressed in order to maximize the
opening space for the removed module.
Note
Fully open both ejector levers on the module being installed. (See
Step 2
78-10826-08
If the captive installation screws are loose, the EMI gaskets on the installed modules will push
the adjacent modules toward the open slot, reducing the opening size and making it difficult to
install the removed module.
Catalyst 6500 Series Power over Ethernet Daughter Cards Field-Upgrade Installation Note
Installing the Ethernet Switching Module
Figure 35.)
39