Removing The Cables - Cisco uBR10-MC5X20S Quick Start Manual

Removing the Cables

Removing the Cables
Step 1
Step 2
Caution
Step 3
Cabling the Cisco uBR10-MC5X20S/U/H Cable Interface Line Card with Universal Cable Holder—UCH2
8
Get user manuals: See SafeManuals.com
Figure 7 Removing the UCH
Red line
1/4 in. flathead
screwdriver
Use the T-10 TORX driver tool to loosen the lock bar on the side you want to remove cables.
Slide the lock bar open by hand, or with a flathead screwdriver if the bar is stuck or hard to access. See
Figure 8.
(Make sure the lock bar is completely open or the cables will not release.)
Be careful not to bend the cables.
Carefully pull the cable out of the hole.
Figure 8 Sliding Open the Lock Bar
US 0
US 1
Shroud
US 2
US 3
US 4
US 5
US 6
US 7
US 8
US 9
OL-24878-01