I Want To Adjust The Temperature In One Room; Select House Control; Select Heating Control And Then The Room - Danfoss Link User Manual

General system information

I want to adjust the temperature in one room

All rooms that are part of the network can be
adjusted centrally using the Danfoss Link™
panel.
You can also set the temperature using the
actual room device, i.e. the living connect® ther-
mostat on the radiator, or the Danfoss Link™ RS
if you have hydronic floor heating.
Please note: If you have a Danfoss Link™ RS in combination
with a living connect® thermostat in the same room,
the desired room temperature is set using only the
room sensor.
Start
House control

Select House control

Please note: Be aware that hydronic floor heating is a
relatively slow-acting heat source. It may
take as long as 8 hours for the desired room
temperature to be reached.
If you have a radiator, you should be aware
that the temperature you set is reached
locally, in the area in which the radiator
is installed or where the room sensor is
mounted. Thus, minor adjustments may be
needed.
link.danfoss.com
Danfoss Link
?
Select Heating control and
then the room
21,5
With the living connect®
thermostat, you can set the
desired room temperature
locally using the thermostat.
If you have two thermostats
in the same room, they will
synchronise automatically.
House control
Heating control
?
If you have a Danfoss Link™
RS, you can see the measured
room temperature here
21,5
^
The Danfoss Link™ RS (stan-
dard with floor heating sys-
tems, extra accessory for ra-
diators with living connect®).
You can set the temperature
locally using the room sensor.
Room temperature
22,2˚
22,0˚
Customize Room
Here you can set the
desired temperature
^
?
VASUA202