Sony Handycam DCR-PC350E Operation Manual page 17

5
Insert your camcorder into the
Handycam Station.
6
Slide the POWER switch up to OFF
(CHG).
The CHARGE lamp lights up and charging
starts.
To charge the battery pack using only
the AC Adaptor
DC IN jack
Mains lead
AC Adaptor
To the wall socket
You can charge the battery pack on a trip, even
if you have not brought the Handycam Station
v
along. With the mark on the DC plug facing
front, connect the AC Adaptor to the DC IN jack
on your camcorder as shown in the illustration.
DC plug
After charging the battery
The CHARGE lamp turns off when the battery
is fully charged. Disconnect the AC Adaptor
from the DC IN jack.
To remove the battery pack
Battery pack
BATT (battery release) lever
1
Set the POWER switch to OFF (CHG).
2
Slide the BATT
lever in the direction of 1 and push it
down in the direction of 2.
Remove the battery pack when it lifts up
in the direction of 3.
b Note
• Be careful not to drop the battery pack when you
remove the battery pack if your camcorder is in a
vertical state.
• Always attach the terminal cover to protect the
battery terminal. If you do not use the battery pack
for a long time, use up the battery pack completely
before storing it. See page 130 about storage of the
battery pack.
To check the remaining battery – Battery
Info
DISPLAY/BATT INFO
POWER
switch
(battery release)
POWER switch
,continued
17
Getting started