Sony Handycam DCR-PC350E Operation Manual page 102

Skip this step if you have selected [i.LINK]
in step 11 on page 99.
b Note
• Run the tape for about 10 seconds before
pausing. The starting scenes may not get
recorded when you start recording from the
beginning of the tape.
3
Touch , then [ADJ TEST].
PROG. EDIT 0:00:00:00
ADJ TEST
Set the recording
device in
rec. pause mode.
EXEC CANCEL
4
Touch [EXEC].
A picture (about 50 seconds long) with 5
[IN] and [OUT] indicators each for
adjusting synchronization is recorded.
[Completed.] appears when the recording is
finished.
PROG. EDIT 0:00:00:00
ADJ TEST
Completed.
5
Rewind the tape on your VCR, then
play back in slow mode.
5 opening numbers for each [IN] and
closing numbers for each [OUT] appear.
6
Take a note of the opening number
value of each [CUT-IN] and the closing
number value of each [CUT-OUT],
then calculate the average number
value for each [CUT-IN] and [CUT-
OUT].
7
Touch [CUT-IN].
102
Dubbing/Editing
PROG. EDIT 0:00:00:00
CUT–IN
0
- 60 ~+ 240
8
Touch /
number value for [CUT-IN], then
touch .
The calculated start position for recording
is set.
9
Touch [CUT-OUT].
PROG. EDIT 0:00:00:00
CUT–OUT
0
- 60 ~+ 240
10
Touch /
number value for [CUT-OUT], then
touch .
The calculated stop position for recording is
set.
11
Touch [END] twice.
Recording the selected scenes as
programs
When you are performing a digital program
edit for the first time to a tape in a VCR, go
through the procedures described in Steps 1
and 2 (p. 98 to p. 101) beforehand.
1
Prepare a cassette or a "Memory Stick
Duo."
Insert a tape to be played back into the
camcorder.
When you are recording on a tape, insert a
cassette for recording into your VCR. When
you are recording on a "Memory Stick
to select the average
to select the average