Cassette Tapes - Sony Handycam DCR-IP1 Operation Manual

Batteries/Power sources
Symptom
The CHG (charge) lamp does not
light while the battery pack is being
charged.
The CHG (charge) lamp flashes while
the battery pack is being charged.
The battery pack is quickly
discharged.
The remaining battery time indicator
does not indicate the correct time.
The power turns off frequently
although the remaining battery
indicator indicates that the battery
pack has enough power to operate.
The power abruptly turns off.
A problem occurs when the
camcorder is connected to the AC
Adaptor.

Cassette tapes

Symptom
The cassette cannot be ejected from
the compartment.
The cassette is not ejected even when
the cassette lid is open.
Cause and/or Corrective Actions
cAttach the battery pack to the camcorder correctly. If the lamp still does
not light up, the power may not be supplied from the wall outlet.
• The battery has already been fully charged. (p. 13)
cInsert your camcorder to the Handycam Station correctly. (p. 4)
cAttach the battery pack to the camcorder correctly. If the problem
persists, disconnect the AC Adaptor from the wall outlet and contact
your Sony dealer. The battery pack may be damaged. (p. 13)
• The temperature of the environment is too low, or the battery pack is not
fully charged. This is not a malfunction.
cFully charge the battery again. If the problem persists, replace the
battery pack with a new one. It may be damaged. (p. 13, 100)
• The camcorder has been used for a long time in an environment too low
or too high in temperature, or the battery pack is not fully charged. This
is not a malfunction.
cFully charge the battery again. If the problem persists, replace the
battery pack with a new one. It may be damaged. (p. 13, 100)
• A deviation has occurred in the remaining battery time, or the battery
pack is not fully charged. (p. 100)
cFully charge the battery again to correct the indication. (p. 13)
• [A.SHUT OFF] in the
(p. 70)
cWhen you leave your camcorder without doing any operation for about
5 minutes after you turn on your camcorder, the power will
automatically turns off. Slide the POWER switch down, then turn on
the power again, or use the AC Adaptor.
cTurn off the power, and disconnect the AC Adaptor from the wall outlet.
Then, connect it again.
Cause and/or Corrective Actions
cMake sure the power source (battery pack or AC Adaptor) is connected
correctly. (p. 13)
cRemove the battery pack from the camcorder, then attach it again. (p. 14)
cAttach a charged battery pack to the camcorder. (p. 13)
• Moisture condensation is starting in your camcorder. (p. 102)
(STANDARD SET) menu is set to [5min].
Troubleshooting
,continued
85