Sony DCR-HC85 Marketing Operation Manual page 15

6
Slide the POWER switch up to OFF
(CHG).
The CHG (charge) lamp lights up and
charging starts.
After charging the battery
The CHG (charge) lamp turns off when the
battery is fully charged. Disconnect the AC
Adaptor from the DC IN jack.
To remove the battery pack
1
Set the POWER switch to OFF (CHG).
2
Lift up the viewfinder.
3
Slide the battery pack out in the direction
of the arrow while pressing the PUSH
button.
b Note
• If you do not use the battery pack for a long time, use
up the battery pack completely before storing it. See
page 130 about storage of the battery pack.
CHG (charge)
lamp
POWER
PUSH
switch
Battery pack
To check the remaining battery – Battery
Info
You can check the battery's current charge level
and its current remaining recording time both
during charging or when the power is turned off.
1
Set the POWER switch to OFF (CHG).
2
Press OPEN and open the LCD panel.
3
Press DISPLAY/BATT INFO.
The battery information appears for about 7
seconds.
Keep the button pressed to view it for about
20 seconds.
BATTERY INFO
BATTERY CHARGE LEVEL
0% 50%
REC TIME AVAILABLE
LCD SCREEN :
VIEWFINDER :
A Battery charge level: Displays
approximate remaining amount of
power left in the battery pack.
B Approximate possible recording time
using the LCD panel.
C Approximate possible recording time
using the viewfinder.
DISPLAY/BATT INFO
POWER switch
100%
54 min
72 min
Getting started
15